Ensiksi pitää vähän korjailla tekstini kun mainitsin ULA-putken anodi. Radio on Philips BSF652 ja tuo putki piti olla EF85:n anodi, eli putki ennen detektoria, ei siis ECC85.
SDR-tikkuni on tällainen:
http://www.radiohistoria.fi/cgi-bin/yabb2/YaBB.pl?num=1445849295/39#39 ja softa on SDR-Sharp.
Tässä tikussa on tunerina R820T2 joka menee reippaasti alle 20 MHz. Tuskinpa pystyy ottamaan 455 kHz:n IF:ä. En ole kokeillut vielä.
LGL
Edit:
Tässä vielä infoa miten saadaan RTL-SDR kuulumaan alle 28,8 MHz.
Feature 1: Direct Sampling HF Mode
This feature allows you to listen to HF signals between about 500 kHz to 28.8 MHz.
To use direct sampling mode
1.  &  &  &Connect an appropriate HF antenna to the SMA antenna port (this is the same port where you connect your VHF/UHF antenna).
2.  &  &  &In SDR# select the Q-branch in the configure menu (the cog icon next to the play button). (If it is greyed out make sure you stop the SDR first, by clicking the stop button in SDR#)
3.  &  &  &Press Play and tune to 500 kHz – 28.8 MHz.